Cooper Instruments & Systems M5-1000 High Capacity Digital Force Gage - Manual (Page 24)

CF 183 21 32-1113 REV 2 1010
11.1 Calibration Password
Select Calibration from the sub-menu. The display will appear as follows:
To set the password, select Enabled, then Set Password. Use the UP and DOWN keys to increment and
decrement the value, from 0 to 9999. When the desired value has been selected, press ENTER, then ESC to
exit the sub-menu.
11.2 Menu Key Password
If enabled, every time the MENU key is selected, a password must be provided. Select Menu Key from the sub-
menu. Follow the same procedure as described in section 10.1.
11.3 Locking Out Other Keys
Other keys may be locked out individually. Select any combination of keys (UNITS, MODE, ZERO, DATA) by
pressing ENTER in the Passwords sub-menu. Pressing a locked key will prompt the message “KEY
PROTECTED” and then revert to the previous screen.
11.4 Password Prompts
If passwords have been enabled, the following will be displayed when pressing the MENU key or accessing the
Calibration section:
25
Use the UP and DOWN keys to select the correct password, then press ENTER to continue.
If the incorrect password has been entered, the display will appear as follows:
To re-enter the password, press ESC to exit to the home screen. Then, access the desired function and enter
the password again when prompted.
If the password has been misplaced, it can be reset. Press ENTER to generate a request code. The request
code must be supplied to Cooper Instruments, who will then provide a corresponding authorization code. Enter
the activation code to disable the password.