CTEK Z4200U SkyRouter - Manual (Page 23)

26 October 2012
19
All other modes where Max Trigger Rate has a time value are level sensitive. So if the contacts close an SMS is sent and
then the state of the relay input is ignored for a defined period of time. For instance, if Max Trigger Rate is set to 5
minutes an SMS is sent and then the relay input is sampled again in 5 minutes. If the contacts are still closed another
SMS is sent. If the relay input is not closed the router reverts to monitoring the relay every second.
SMS Destination Address – This field contains the mobile phone numbers or email addresses to which the SMS
message will be sent. Up to five phone numbers or five email addresses may be defined within the following limitations
1. Field length - This field can contain no more than fifty-four (54) characters in total including spaces or commas
2. Phone Numbers - Each phone number must consist of ten (10) numeric characters. Multiple phone numbers may
be separated by commas or spaces. Therefore, the following formats are allowed:
nnnnnnnnnn,nnnnnnnnnn,nnnnnnnnnn,nnnnnnnnnn,nnnnnnnnnn or nnnnnnnnnn nnnnnnnnnn nnnnnnnnnn
nnnnnnnnnn nnnnnnnnnn
3. Email Addresses - email address must be in the form recipient@Any_Domain. The recipient portion of the email
address must contain a non-numeric character in the first ten characters specified or be less than 10 characters in
length. An email address may not exceed forty (40) characters in length. Multiple email addresses may be
separated by commas or spaces.
4. Destination phone numbers and email addresses may be interspersed so long as the rules defined above are
adhered to.
SMS Alert Message – The text of the message to be sent when the relay interface activates. Limited to 100 characters
maximum. Only printable ASCII characters in the range of 32 – 126 decimal (20 – 7E hex) can be included in the
message.
4.2.3 Configuring The Relay Output (Driver) Interface
This screen configures the connection characteristics of the relay output interface and defines the service associated with
this interface. Currently, the relay output interface can be activated by an SMS message or from a button that can be
defined on the Advertising screen described in the Services section.
Appendix A contains schematic information concerning the relay output configuration.