CTEK Z4200U SkyRouter - Manual (Page 44)

26 October 2012
40
Local IP Address
The IP address assigned to the router end of the PPP connection. This is the address that should be used in the routing
screen for devices on the PPP connection.
Remote IP Address
The address of the remote end of the PPP connection. It may refer to a device or a router managing another subnet.
LCP Echo -On/Off
Enables or disables the LCP Echo message over the PPP connection
DNS Address Source – In most cases this parameter should be set to Acquire From Wireless Network. In this case,
when you click on the Update button, the router will verify that it has been connected to the wireless network and that the
wireless network has provided DNS addresses. If DNS addresses have been provided, they will be displayed in the
Primary and Secondary Address boxes. If addresses have not been provided, you will receive an error indication. At that
point, you should allow the router to establish a connection with the wireless network so that it can acquire the DNS
addresses. You should then go back into the Ethernet Configuration screen and click on submit again. At this point, the
DNS addresses should appear.
If you application requires a specific DNS setting check the User Defined box and manually fill in the DNS IP Address
fields below.
DNS IP Address (Primary and Secondary) – The address of the Domain Name Server that your network uses. This
should not be confused with the Name Server entries on the Wireless Interface screen. The DNS referenced by these
addresses will resolve outbound queries.
4.4.5 Admin Screen Services
This service allows the user to control overall local and remote administrative access.
Figure 29 - Admin Screen Control