CTEK Automation Control Application APN007 User Manual
Page 15
Application Note – Automation Control Application
APN007 25 July, 2014
10
Note:
The default commend described above uses a broadcast that will set the address of all physical
modules to 99. You may want to disconnect modules from the line up that do not require their
address to be resored to default.
Disable
Disabling a module removes it from the communications routine. All set up information for the
disabled module remains intact. Disable can be a useful troubleshooting tool when diagnosing
communications problems or configuration issues.To disable a module enter its module number
and press submit.
Figure 9 - Disable I/O Module
Enable
Enabling a module returns a disabled module to service. Setting previously stored on the module
will be used. To enable a module enter its module number and press submit.
Figure 10 - Enable Module