Yealink SIP-T48G - Manual (Page 31)

Getting Started
21
4. Enter the desired values in the IP Address, IPv6 IP Prefix, Gateway, Primary DNS and
Secondary DNS fields respectively.
5. Tap the Save soft key to accept the change or to cancel.
If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE
mode. Set the WAN port as a PPPoE port. The PPPoE port will perform a PPP negotiation
to obtain the IP address. Contact your system administrator for the PPPoE user name
and password.
To configure PPPoE via phone user interface:
1. Tap ->Advanced (password: admin) ->Network->WAN Port->IPv4.
2. Tap the gray box of the Type field.
3. Tap PPPoE from the pull-down list.
4. Enter the PPPoE user name and password in the corresponding fields.
5. Tap the Save soft key to accept the change or to cancel.
Note Wrong network settings may result in inaccessibility of your phone and may also have an
impact on your network performance. For more information on these parameters,
contact your system administrator.