Bissell 1456E - Manual (Page 12)

Maintenance & Care
machine storage
Put unit away in a closet or basement for next
use. store cleaner in a protected, dry area. since
this product uses water, it must not be stored
where there is a danger of freezing. Freezing will
damage internal components and void guarantee.
fluid connection point filter maintenance
Periodic cleaning of fluid connection point
filters in spray nozzle may be required.
1. To clean fluid connection point filters,
remove nozzle and turn it over.
2. Clean filters on ends of fluid connection
points with a small paperclip and re-attach
nozzle to machine.
Drive belt removal & replacement
Occasional replacement of one or both belts
may become necessary. if needed, please follow
instructions below.
1. Turn off machine, and unplug it from outlet.
Wrap hose and cord on racks.
2. Remove 2-in-1 water tank and set aside.
3. Remove nozzle by turning locking keys
counterclockwise to “unlock” position and
lifting nozzle up and away.
4. Turn machine on its side. Important: make
sure corded side is facing up.
5. Remove 1 silver screw from pivot arm.
6. Remove pivot arm by gently lifting up.
7. Remove old drive belt and replace it with
a new belt by first attaching it to small drive
wheel, then attaching it to end of inside brush.
8. Place pivot arm back on and secure in place
using silver screw.
9. Replace nozzle by lining up locking keys with
their slots and placing nozzle back onto foot of
machine. secure into place by turning locking
keys clockwise to “lock” position.
1. 2.
www.bissell.com
12
1
4
6
8
2.
3. 4.
5. 6.
7. 8.
9.
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.