Bissell 1456E - Manual (Page 14)

www.bissell.com
14
Troubleshooting
problem possible causes Remedies
Reduced
spray or
no spray
bladder may be empty
Press power button
off; refill
bladder with clean hand hot
(60°F/140°C MAX) tap water and
formula.
2-in-1 tank may not be seated
properly
Press power button off;
remove and reseat tank so it
sits snugly on machine.
Pump may have lost prime.
Press power button
off;
after 1 minute turn on and depress
spray trigger.
Dirtlifter
powerbrush
does not turn
belts are off or broken
Press power button
off and
unplug unit from outlet. Follow
instructions on pages 12 and 13.
Circuit breaker on machine may
have tripped
Press power button
off and
unplug from outlet. Check to see if
foreign object is caught in brush roll.
Remove object. Plug machine in to
reset circuit breaker.
cleaner
not picking
up solution
2-in-1 tank may not be seated
properly
Press power button
off;
remove and reseat tank so it
sits snugly on machine.
2-in-1 tank may not be assembled
properly
Make sure tank latches on both sides
of tank are latched properly.
2-in-1 water tank has picked up
maximum dirty water and red
float door has closed.
empty 2-in-1 tank and refill, refer
to the Operation section.
Red float "door" in tank may have
closed as a result of bumping
object or moving machine back
and forth too quickly
Press power button
off, allowing
red float door to release back into
open position. Press power button
back on to continue cleaning. be sure
your forward and backward strokes
are done at a slower pace.
Red lint screen near air duct
is dirty
Follow cleaning instructions in
step 4 on page 11.
Other maintenance or service not included in the manual should
be performed by an authorized service representative.
Thank you for selecting a bissell product.
please do
not return
this product
to the store.
WARNING
To reduce the risk of electric shock, push power button
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.