Bissell 1456E - Manual (Page 5)

www.bissell.com
5
Your deep cleaner comes in four easy-to-
assemble components:
Upper Handle with Screws
lower base
Upper Hose Rack
Upper tool Holder
The only thing you will need to assemble
your cleaner is a Phillips head screwdriver.
1. side upper handle onto lower base and secure
by screwing 2 screws into marked holes on back
of lower base (screws will be taped to the
handle grip).
2. Attach upper tool holder to upper handle
by snapping bottom half in first, then snap in
top half.
3. Place upper hose/cord rack onto back side
of upper handle and secure by screwing 1 screw
into hole at bottom of rack.
4. Wrap hose around lower and upper hose/cord
racks and secure it by inserting trigger on hose
grip into opening on hose grip holder located on
upper hose/cord rack.
NotE: make sure to wrap hose beginning
from back of bottom hose/cord rack and then
wrapping over and around top of upper hose/
cord rack.
5. Wrap cord around lower and upper hose/cord
racks and secure plug to cord with clip on plug.
6. Attach cleaning tools as necessary to storage
locations on upper tool holder, bottom hose/
cord wrap and end of hose grip.
Deep cleaner assembly is now complete.
Assembly
4.
3.
2.
1.
WARNING
Do not plug in your deep cleaner until you are familiar with
all instructions and operating procedures.