EcoPure MW_MW30_7301415A - Manual (Page 23)

23 Miracle Water Installation & Operation Manual
Cleaning the Nozzle and Venturi
A clean nozzle and venturi (see Figure 14) is a must for the conditioner to work properly. This small
unit creates the suction to move brine from the brine tank, into the resin tank. If it should become
plugged with sand, silt, dirt, etc., the conditioner will not work, and you will get hard water.
To get to the nozzle and venturi, slide Faceplate Cover forward.
Be sure the unit is in soft water
cycle (no water pressure at nozzle and venturi). Then, holding the nozzle and venturi housing with
one hand, turn off the cap. Do not lose the o-ring seal. Lift out the screen support and screen.
Then, remove the nozzle and venturi. Wash the parts in warm, soapy water and rinse in fresh
water. If needed, use a small brush to remove iron or dirt. Be careful not to scratch, misshape, etc.,
surfaces of the nozzle and venturi. Also, check and clean the gasket and flow plug(s).
Carefully replace all parts in the correct order. Lubricate the o-ring seal with silicone grease and
locate in position. Install and tighten the cap, by hand only. Do not overtighten and break the
cap or housing. If you have questions about routine maintenance...
call 1-800-356-7851