Wx y z – Edge Lighting TruLine 1.6A, 24VDC - Plaster-In LED system User Manual
Page 8
Advertising
8
1: Install junction box and low-voltage power.
2: Measure and mark installation length. Cut out marked
areas using appropriate tools.
3: Insert the #4-40 Torx screws through the end cap holes and
thread into the TruLine 1.6A starter channel section.
4: Tighten the end cap to the channel using the provided T10
Torx screwdriver.
5: Install the assembled end cap and trap door frame
to the junction box using the #6-32 screw..
6: Measure installation length from inside edge of assembled
trap door frame section to the ceiling.
7: Repeat measurement steps for additional sections to
determine all required channel cut lengths.
W
X
Y
Z
1
END CAP
TRAP DOOR
FRAME
T10 TORX
3
4
5
WALL
CEILING
JUNCTION
BOX
INSTALLATION
AREA
INSTALLATION
AREA
#6-32 SCREW
6
WALL
CEILING
Advertising