FASS T D09 095G User Manual
Page 12
Advertising
F.
Connect factory plug into the FASS harness. Connect female plug of the FASS harness into pump.
Turn key to “on”. With pump operating (you may have to bump the starter), turn pump over, liberally
spray WD-40 (or equivalent) into water separator nipple lubricating Gerotor.
E.
Position the PBR-2001 to the PFB-2002 pump assembly at the mounting location and check for fit.
Once location is established mark location for mounting in next step.
D.
Secure PFB-2002 and RS-2001 with bed bolt in previous step.
C.
Unbolt driver side front bed bolt from bed retain bolt for future use. Align RS-2001 with PFB-2002.
.
Advertising