FASS T D09 095G User Manual
Page 9
Advertising
G.
Route wire harness along frame to the mounting location of the FASS pump. Completion of this step
will be addressed in the Mounting Step.
F.
Locate fuse box under hood and select ignition hot fuse. Remove fuse and put Add-A-Fuse in place.
Install fuse previously removed. The use of a corrosion preventative on electrical connections is
recommended.
E.
The red lead of the wire harness will travel thru the rubber grommet
or into the fuse panel in the engine compartment. The use of corro-
sion preventative spray is recommended.
Advertising