Locking the doors, Locks and security – FORD 2010 Expedition v.3 User Manual

Page 173

Advertising
background image

Two stage unlocking may be disabled or re-enabled by simultaneously
pressing the

and

controls on the IKT for four seconds (disabling

two stage unlock allows all vehicle doors to unlock simultaneously). The
parking lamps will flash twice to indicate that two-stage unlock was
enabled or disabled.

Locking the doors

1. Press

and release to lock all the doors. The parking lamps will

illuminate.

2. Press

and release again within three seconds to confirm that all

the doors are closed. Note: The doors will lock again, the horn will chirp
and the turn lamps will illuminate once if all the doors and liftgate are
closed.

Note: If any door or the liftgate is not closed, or if the hood is not
closed in vehicles equipped with the perimeter alarm feature, the horn
will chirp twice and the turn lamps will not flash.

Opening the power liftgate or liftgate window (if equipped)

If equipped with a power liftgate, this control will not operate the liftgate
window.
• Press

twice within three seconds to open the power liftgate (if

equipped) or

• Press

twice within three seconds to unlatch the liftgate window

(if not equipped with a power liftgate).

WARNING: Make sure all persons are clear of the power liftgate
area before using the control.

To close the power liftgate, press the control twice.

If the power liftgate stops mid travel, it may have detected an obstacle,
Check to ensure the power liftgate swing zone is free from obstruction
and reset the power assist by manually closing the power liftgate. Normal
operation can then be resumed.

WARNING: Make sure the power liftgate is closed to prevent
exhaust fumes from being drawn into the vehicle. This will also

prevent passengers and cargo from falling out. If you must drive with
the liftgate open, keep the vents open so outside air comes into the
vehicle.

Locks and Security

173

2010 Expedition (exd)
Owners Guide, 3rd Printing
USA
(fus)

Advertising
This manual is related to the following products: