FORD 2002 Focus v.2 - Manual (Page 116)

Locks and Security
116
Replacing lost transmitters
If a remote transmitter has been
lost and you would like to remove it
from the vehicle's memory, or you
would like to purchase additional
transmitters for your vehicle (up to
four may be programmed into
memory), take all your vehicle's
remote transmitters either to your
dealer or perform the programming
procedure yourself. It will be
necessary to reprogram all the
remote transmitters to your vehicle
at the same time while performing
this service.
Programming procedure
1. Close all doors and fasten the
seat belt to ensure conflicting
chimes do not sound during
programming.
2. Turn the ignition lock from OFF
(2) to ON/RUN (3) at least 4 times
in 6 seconds.
3. Switch off the ignition.
Now the control module has
entered the learning mode" for
10 seconds. This mode is indicated
by a chime.
4. While the control module is in
the learning mode", press and hold
one of the buttons of the remote
transmitter until a chime sounds.
This indicates a new transmitter
code has been successfully
received. After each successful
programming, another 10 second
learning mode" is automatically
entered, up to a maximum of four
times. Another transmitter can now
be programmed (repeat step 4).
1