FORD 2002 Windstar v.1 - Manual (Page 98)

Canadian Programming
During programming, your hand-held transmitter may automatically stop
transmitting after two seconds which may not be long enough to
program the HomeLink
௡ Universal Transceiver.
To program your hand-held
transmitters:
• Continue to hold the button on
the HomeLink
௡ Universal
Transceiver.
• Press and re-press the hand-held
transmitter button every two
seconds until the red light changes from a slow to a fast flash.
Operating the HomeLink
ா
Universal Transceiver
Once programmed, the HomeLink
௡
Universal Transceiver can be used in
place of hand-held transmitters. To
operate, simply press and release
the appropriate HomeLink
௡ button
(the red light will illuminate,
indicating the signal is being
transmitted).
Rolling code programming
Rolling code garage door openers (or other rolling code devices) which
are “code protected” and manufactured after 1996, may be determined
by the following:
• Reference the device owner’s manual for verification
• The hand-held transmitter appears to program the HomeLink௡
Universal Transceiver but does not activate the device.
• Press and hold the trained HomeLink௡ button. The device has the
rolling code feature if the indicator light flashes rapidly and then turns
solid after two seconds.
Driver Controls
98