HeatStream HS-215T-KFA - Manual (Page 9)

3. Using a small amount of kerosene, rinse and swirl the
kerosene inside of the Fuel Tank. Empty the tank fully.
4. To replace, push the drain head fully into the drain hole and
secure by pushing the seal cap fully into the head hole (See
Figure 12).
IMPORTANT: Never store leftover kerosene over the summer.
Using old fuel can damage your heater.
© 2012, Pinnacle Products International, Inc. 9 Kerosene User’s Manual
Drain Plug
Fuel Tank
Seal Head
Head Flange
Head
Flange
Cap Flange
Seal Cap
Operation (Continued)
Figure 12: Drain Plug Reinstall
Maintenance
Never service heater while it is plugged in
or while hot!
Use only original equipment replacement parts. The use of
alternate or third party components can cause unsafe operating
conditions, and will void your warranty.
We suggest following a maintenance schedule as follows:
FUEL/FUEL TANK:
Flush every 200 hours of operation or as needed. Do not use
water to flush the tank. Use fresh 1-K kerosene only.
AIR FILTERS:
The Air Intake Filter should be replaced or washed with soap and
water and dried thoroughly every 500 hours of operation, or less,
depending on conditions.
The
Output and Lint Filters should be replaced every 500 hours
of operation or less, depending on conditions.
NOTE: Use of diesel may require additional maintenance..
FAN BLADES:
Blades should be cleaned at least once per heating season,
depending on conditions.
Remove all accumulated dust and dirt with a damp cloth, taking
care not to bend any of the fan blades. Be sure fan blades are
dry before re-starting the heater. For Fan removal, see Figure
14.
WARNING
Air Output Filter
Intake Filter
End Filter Cover Lint Filter
Figure 13: Filter Replacement
Motor Shaft
Set Screw
Fan Blade
Flush
Figure 14: Fan Replacement
NEVER LEAVE HEATER
UNATTENDED WHILE BURN-
ING OR WHILE CONNECTED
TO A POWER SOURCE