Hudson Robotics LabLinx - Manual (Page 11)

StackLink User Manual Hudson Robotics, Inc.
7
Setting Up StopLink(s)
 Position the StopLink in the desired location on the track and secure its position
with the supplied Phillips head screws. (Figure 12)
 Connect modular plugs of the black coiled cable into both the StopLink and the
desired port on the side of the StackLink (Figure 9/10).
 Adjustments may be needed depending on the size and type of plates used. Place
a plate on the track in front of the StopLink sensor to activate the fingers. Loosen
the 2 hex screws on the StopLink (Figure 8) and adjust the width of the sides so
the plate is secure between the fingers without any movement.
Figure 8
StopLink Positions 1-4
Figure 9
Adjustment
screws