Hudson Robotics LabLinx - Manual (Page 13)

StackLink User Manual Hudson Robotics, Inc.
9
Figure 12
Connect Power Cord & Communication Cable:
Note: Power switch must be turned OFF
Remove power cord and communication cable from StackLink carton.
On the rear side of the base unit housing connect one end of the 9-pin to 9-pin serial cable
(see Figure 7), and attach the other end into COM1 port on Host Computer.
Plug power cable into the StackLink's AC inlet located on rear side of the base unit
housing (see Figure 7).
Note: The communication cable & power cord should be securely plugged into the
StackLink and computer.
Switching AC Line Voltage 110VAC/220VAC
The power supplies installed in the unit are switching power supplies. That means they
are able to handle both 110VAC and 220VAC without any changes to their configuration.
The Run the StackLink on 220VAC perform the following:
 Make sure the unit is powered off
 Install the power cord that is supplying the 220VAC
 Turn on unit
Phillips Head
screws positioning