Hudson Robotics PlateCrane EX - Manual (Page 15)

PlateCrane EX User Manual Hudson Robotics, Inc.
11
7. Installing PlateCrane Stacks:
Note: Mishandling of plate stacks can result in misalignment.
 Unpack and unwrap the input/output stacks
 Mount the stacks onto the stack base by gently sliding them down onto the stack
guide blocks.
8. Installing Barcode Scanner:
 If the Barcode Scanner option was purchased, position the scanner stand just
outside the outer edge of the plate magazines, so that a plate's label can be
scanned above the top of the stacks.
 Secure the scanner platform to the scanner stand post, and run its RS-232 cable to
an available COM port on the host computer. Plug its 5-VDC power supply into a
nearby 120 VAC receptacle.
9. Unplugging Power and Communication Cables:
During service or moving the unit will have to have the power and
communication cable removed. To unplug the two cables perform the
following:
 The Rear of the PlateCrane should be facing you (See figure 11)
 Unplug the power cable by holding the power cable as close to the
PlateCrane as possible and pulling gently straight away from the
PlateCrane
 Unplug the communication cable by loosening the two thumbscrews
that secure the cable to the PlateCrane then slowly pull the cable
straight away from the PlateCrane.