Hudson Robotics PlateCrane EX - Manual (Page 20)

PlateCrane EX User Manual Hudson Robotics, Inc.
16
in left click on the initialize Plug-in button. If the instrument is installed on the correct
communication port and the instrument is powered on then the status screen will then
change to initialized.
If the status comes back that it could not communicate with the firmware, then it is either
attached to the wrong communication port or the instrument is not turned on.
Once the PlateCrane is initialized successfully, then you can left click on the Plug-in
setup button. This button will open the calibration window for the PlateCrane.
4. Plug-in Setup
For the PlateCrane the Plug-in setup button contains the calibration screen for the
PlateCrane. First left click on the PlateCrane name in the workcell list. After it is
highlighted, click on the Plug-in setup button to open the calibration screen.