CITIZEN CBM-270 - Manual (Page 51)

CBM-270 User’s Manual
CITIZEN 51
ESC ! n
[Function] Collective specifying the printing mode
[Code] <1B> H <21> H <n>
[Range] 0 £ n £ 255
[Outline] Printing mode is assigned. Each n bit indicates the following:
Value
Bit Function
0 1
0 Character Font Font A Font B
1 Undefined
2 Undefined
3 High-lighting Canceled Specified
4 Double height Canceled Specified
5 Double width Canceled Specified
6 Undefined
7 Underline Canceled Specified
[Caution] · With double height and double width being specified simultaneously, double
wide and double high characters are consisted.
· An underline is attached to the full character width, which, however, is not
attached to the part having been skipped by the horizontal tab. Neither is it
attached to 90°-right-turned characters.
· The underline width is as having been specified by <ESC - >. (The default
setting is 1 dot width. )
· Specification with this command is invalid to Kanji, except specification and
cancellation of highlighting
· In case that double wide character and normal character exist in same one line,
the layout of underline is consistent one.
[Default] n = 0
[See Also] ESC E, ESC -
[Sample Program]
LPRINT CHR$ (&H1B) ; " ! " ; CHR$ (&H00) ; "H" ;
LPRINT CHR$ (&H1B) ; " ! " ; CHR$ (&H01) ; "H";
LPRINT CHR$ (&H1B) ; " ! " ; CHR$ (&H08) ; "H";
LPRINT CHR$ (&H1B) ; " ! " ; CHR$ (&H10) ; "H";
LPRINT CHR$ (&H1B) ; " ! " ; CHR$ (&H20) ; "H";
LPRINT CHR$ (&H1B) ; " ! " ; CHR$ (&H80) ; "H";
LPRINT CHR$ (&H1B) ; " ! " ; CHR$ (&HB9) ; "H";
LPRINT CHR$ (&HA) ;
END
[Print Results]