CITIZEN CBM-270 - Manual (Page 64)

CBM-270 User’s Manual
CITIZEN 64
ESC c 3 n (Parallel Interface Only)
[Function] Selecting the paper near end sensor valid for a paper end signal output
[Code] <1B>H<63>H<33>H<n>
[Range] 0 £ n £255
[Outline] This command selects at which paper near end sensor a paper end signal should
be output. Each bit for n has the following meaning:
Value
Bit Position
0 1
0 Paper near end Disabled Enabled
1 ~ 7 Undefined
This printer can only select one kind of paper end detection, a paper-near-end
sensor. n is valid for the least significant bit (n0).
[Caution] This command is valid only for the parallel interface.
[Default] A default of n is what has been set with the DIP switch (DS1-1).
[Sample Program]
LPRINT CHR$(&H1B);"c3";CHR$(0);
·······When outputting the paper-end signal at the paper end
LPRINT CHR$(&H1B);"c3";CHR$(1);
·······When outputting the paper-end signal at the paper near end
ESC c 4 n
[Function] Selecting the paper near end sensor valid for print stop
[Code] <1B>H<63>H<34>H<n>
[Range] 0 £ n £ 255
[Outline] This command selects at which paper near end sensor printing should be stopped.
Each bit for n has the following meaning:
Value
Bit Position
0 1
0 Paper near end Disabled Enabled
1 ~ 7 Undefined
This printer can only select one kind of paper-end detection, a paper-near-end
sensor. n is valid for the least significant bit (n0).
[Caution] If print stop is enabled, the printer will print (Feed the paper) 150 cm or an
amount of data specified with the ESC n command and go off-line.
[Default] A default of n is what has been set with the DIP switch (DS1-1).
[Sample Program]
LPRINT CHR$(&H1B);"c4";CHR$(0);
·······When stopping printing at the paper end
LPRINT CHR$(&H1B);"c4";CHR$(1);
········When stopping printing at the paper near end