Canon LV-7275 EN - Manual (Page 15)

6
. Introducton
3 3 7 8 1 2
4 6 5 10 9
Terminal Panel Features
. Computer  Input Connector [ANALOG IN-]
(Mn D-Sub  Pn)
Connect your computer or other analog RGB equip-
ment such as IBM compatible or Macintosh com-
puters. Use the supplied VGA cable to connect to
your computer. This also serves as a component
input connector that allows you to connect a com-
ponent video output of audio-video equipment.
See page
14 , 17 , 19 .
. Computer  Input Connector [DIGITAL IN/ANA-
LOG IN-] (DVI-I 9 Pn)
Connect the DVI output of your computer or other
digital RGB equipment such as IBM compatible or
Macintosh computers.
You can also use the supplied DVI to VGA adapter to
connect the output of analog RGB equipment.
See page
16 , 17 , 21 .
. AUDIO IN Mn Jack (Stereo Mn)
This is where you connect the audio output from
your computer or audio-video equipment when con-
nected to the ANALOG IN-1 or 2 input. A commer-
cially available audio cable is required.
See page
14 , 16 , 18 , 19 , 21 .
. MONITOR OUT Connector [ ] (Mn D-Sub  Pn)
You can use this connector to loop your computer im-
age to an external monitor from the RGB input source
(ANALOG IN-1).
This connector outputs RGB signal in standby
mode. See page
18 .
. AUDIO OUT Mn Jack (Stereo Mn)
You can use this jack to output sound from the cur-
rently selected source (COMPUTER, VIDEO or
S-VIDEO). Output sound level can be adjusted in ac-
cordance with the sound level of the internal speaker.
Note that this cannot be used as a headphone jack.
(When audio equipment is connected, the projector
speaker is disabled.)
When a cable mini-plug is inserted into this jack, both the
right and left audio signals are not mixed, but separate.
For example, when a cable mini-plug is inserted into
the left AUDIO IN jack only, only left sound is output.
6. VIDEO IN Connector (RCA)
Connect audio-video equipment here to project video.
See page
20 .
7. S-VIDEO IN Connector (Mn DIN  Pn)
Here is where you connect the S-Video input from
audio-video equipment.
See page
20 .
NOTE: S-Video provides more vivid color and higher reso-
lution than the traditional composite video format.
8. AUDIO IN Jacks L/R (RCA)
These are your left and right channel audio inputs for
stereo sound from a Video/S-Video source.
See page
20 , 21 .
9. SERVICE PORT (D-Sub 9 Pn)
Use this port to connect a computer or control sys-
tem.
This enables you to control the projector using se-
rial communication protocol. If you are writing your
own program, typical PC control codes are on page
82 .
0. LAN Port [ ] (RJ-)
Use this port when controlling your projector in LAN
connection from a computer. Use a commercially
available LAN cable (10 Base-T/100 Base-T) to con-
nect the projector to the computer. See page
22 .