Baumer CleverLevel - LFFS - Manual (Page 6)

Operators instructions
CleverLevel switch, LFFS
Teach-In using the FlexProgram and FlexProgrammer 9701
Sophisticated settings for Teach-In as well as output type, diagnostics, data logging, tag no. and damping can be configured using
the FlexProgrammer 9701. Integrated HELP-menus will give full instruction.
Press  or  to browse the menus
 to access current menu point
 to return to previous menu
 and  simultaneously to reset FlexProgrammer
and go in sleep mode
Teach-In
Press

and  simultaneously
Select Menu “Teach-In”

Search for product
= Product LFS/LBFS
 At empty tank setting 0%
 At full tank setting 100%
Manually Teach-In
Make sure that power is on before Teach-In.
For best Teach-In it is important the product is fixed in the final application.
During Teach-In mode the light intensity of the LED will decrease, please protect your eyes.
Step To do LED Result
1
Connect terminal ”Teach-In” to
- VDC (T1 or T2) for 3,5 second
Flash 1 time per second
Ready for Teach-in
2
With no media present connect
”Teach-In” to - VDC shortly
Light on for 2 second and then flash
Register ”empty” state. Pls. See note
3
With media present connect
”Teach-In” to - VDC shortly
Light on for 2 seconds
Register ”full” state, stores the value and returns to
Normal operation with new setting
NOTE:
If the media is sticky, foamy, powdery or in other ways leaving parts of the media at the sensor tip this situation has to be estab-
lished also during the Teach-In process. Otherwise a faulty calibration can be the result.
If Teach-In for some reason do not succeed, the CleverLevel Switch LFFS will enter “Error State” and automatically reload factory
settings . The factory settings can always be reloaded by connecting the terminal “Teach-In” to -VDC for more than 6.5 seconds.
A reloaded factory settings will be confirmed by pulsing light intensity 3 times.
Error state description LED Result
Error state Blinking, 3 × short and 1 × long Can normally be fixed by powering off and on and remake the Teach-In.
Alternatively remake the Teach-In configuration by use of the FlexPro-
gram and the FlexProgrammer 9701
Using the FlexProgrammer 9701 alone and Teach-In
FlexProgrammer 9701 stand alone menu
Press
 Turn on FlexProgrammer if in sleep mode
Empty configuration
 Search for product
LFFS/LBFS configuration
 Product LFFS / LBFS
 TAG number xxxxxxxxxxxxxxx
 Range min. x.x%
 Range max. xx.x%
 Damping x,x sec
 Output config. Xxxxxxx
 Trigger level
xx,x%
 Range hyst. x,xx%
 Trigger hyst. x.xx%
www.baumer.com Operators instructions: 11109132 02 EN Page 6 / 12