Camco Amplifier - Manual (Page 26)

4 OPER
ATION
3
4
5
1
2
USER MANUAL
VORTEX 3 QUADRO P.24
4.7 Filter Cleaning
The air intake on the front of your VORTEX is fitted with a removable filter
system. If the filter becomes clogged, the unit will not cool as efficiently as it
should and may result in reduced output levels.
For changing the filter, no tools are required: first, gently slide the whole plastic
filter assembly a few millimetres to the left and lift it from the front panel. Next,
beginning on one of the long sides, carefully unclip the moulded surround (4)
from the cradle (2) and then carefully pull the CAMCO badge (5) out of the four
fastening holes with both hands. Remove the foam filter (3) and clean it with a
mild dishwashing detergent and warm water. Once dry, replace the foam filter
carefully into the cradle and repeat the dismantling procedure in reverse. Insert
the five pins on the filter frame into the clip apertures () and slide the filter
carefully to the right to secure.
Spare filter assembly’s may be ordered from your dealer/distributor.
VORTEX Filter Assembly
 Clip Apertures
2 Injection Moulded Cradle
3 Foam Filter
4 Injection Moulded Surround
5 Injection Moulded CAMCO Badge