Camco Amplifier - Manual (Page 28)

5 OPTIONS
0

2
3
4 5
6
7
8
9
0

2
3
4 5
6
7
8
9
0

2
3
4 5
6
7
8
9
0

2
3
4 5
6
7
8
9
USER MANUAL
VORTEX 3 QUADRO P.26
To adjust the address you can use the scale markings of the potentio-
meters. You will find the digits 0,1,...,9 on the 10 scale spacing.
The current selected address of amplifier A/B will be immediately displayed but
not automatically stored or activated! After each turn of pot you have another
30 seconds to timeout. You can leave this procedure without saving the new
addresses by briefly pressing the Enter-Switch
or waiting for timeout (as
described above).
To store and activate the new addresses you have to press the Enter-Switch
for 3 seconds. These new addresses are stored in an EEPROM, which holds the
information even if the amp is subsequently disconnected from mains. Be sure
to set the CAI-Master-PC to these new addresses. If not, the communication will
be interrupted.
Example of LED sequences for different address settings:
Adresses (A/B)/(C/D) On-LED Channel A => Tens On-LED Channel B => Units
0/02 (factory settings) 0* flash * flash then short pause
25/26 2* flashes then short pause 5* flashes then short pause
NOTE: Ensure you return both pots to their original position after address
selection is complete, otherwise the amplifier will change its volume level
to the new pot positions!
5..3 CAI Status Indicator
This green LED indicates the presence of communication between PC and the
amp.