Baumer BA Scatec2 Gripper - Manual (Page 3)

20101215_Shortmanual_ScatecDCC_EN.doc 3/10 Baumer Electric AG
15.12.2010 / wej Frauenfeld, Switzerland
1 Mechanical Setting & Adjustment
Typically, the Scatec is mounted in an angle of 20 ° to the magazine’s position.
(ill. 1)
Among the products a leading plate should be installed. These should be mounted close under the gripper
(eg h
e
= 50 mm to 70 mm below the lowest point of the gripper).
The leading plate should have a bright, matte surface (eg matte aluminum plate).
(ill. 2)
about 20°
Scatec
magazines
direction of
transportion
Leading plate
Scatec
Leading plate
h
e
magazines
gripper
Holding point