Baumer BA FADx14 IO - Manual (Page 3)

BA_FADK14IO-Link_V01-02-11_EN.doc 3/18 Baumer Electric AG
04.12.2012 Frauenfeld, Switzerland
1 General Information
1.1 About this Document
These instructions contain information related to commissioning and communications with the Baumer Se-
ries 14 photoelectric distance sensor equipped with the IO Link interface. They supplement the installation
instructions, already provided with each sensor.
These instructions apply to the following sensor versions (software version 01-02-11):
FADK 14I4470/IO
FADK 14I4470/S14/IO
FADK 14I4470/S35A/IO
FADK 14U4470/IO
FADK 14U4470/S14/IO
FADK 14U4470/S35A/IO
1.2 General Information
Rules for proper
usage This product is a precision measuring device which has been designed for the
detection of objects and parts. It generates and provides measured values issued
as electrical signals for following systems. Unless this product has not been spe-
cifically marked it may not be used in hazardous areas.
Set-up Installation, mounting and adjustment of this product may only be executed by
skilled employees.
Installation Only mounting devices and accessories specifically provided for this product may
be used for installation. Unused outputs may not be connected. Unused strands
of hard-wired sensors must be isolated. Do not exceed the maximum permissible
bending radius of the cable. Before connecting the product electrically the system
must be powered down. Where screened cables are mandatory, they have to be
used in order to assure EMI protection. When assembling connectors and
screened cables at customer site the screen of the cable must be linked to the
connector housing via a large contact area.