Installing the expansion card stabilizer – Dell PowerEdge T610 User Manual
Page 91
Advertising
Installing System Components
91
Figure 3-8.
Removing and Installing the Expansion Card Stabilizer
Installing the Expansion Card Stabilizer
1 Slide the edge of the expansion card stabilizer into the slots in the
chassis until the release tab locks into place. See Figure 3-8.
2 Close the system. See "Closing the System."
3 Place the system upright and on its feet on a flat, stable surface.
4 Reattach any peripherals, then connect the system to the electrical outlet.
5 Turn on the system and attached peripherals.
1
release tab
2
expansion card stabilizer
3
chassis slots
1
2
3
book.book Page 91 Tuesday, September 15, 2009 10:08 AM
Advertising