Installing a cooling-fan module – Dell PowerEdge T610 User Manual
Page 95
Installing System Components
95
Figure 3-10.
Removing and Installing a Cooling-Fan Module
Installing a Cooling-Fan Module
CAUTION:
Never attempt to operate your system without at least one cooling-fan
module installed. If only one cooling-fan module is being installed, it must be
installed in the outer module position in the cooling shroud.
1 Hold the replacement cooling-fan module by the release tabs, and align
the tabs on the module with the securing slots on the cooling shroud.
2 Slide the module down into the cooling shroud until the release tabs lock
into place. See Figure 3-10.
3 Install the cooling shroud. See "Installing the Cooling Shroud."
4 Install the expansion card stabilizer. See "Installing the Expansion Card
1
release tabs (2)
2
cooling-fan module
3
cooling shroud
4
outer fan-module slot
2
3
1
4
1
book.book Page 95 Tuesday, September 15, 2009 10:08 AM