Cooling shroud, Removing the cooling shroud – Dell PowerEdge T610 User Manual
Page 92
92
Installing System Components
Cooling Shroud
Removing the Cooling Shroud
WARNING:
The memory modules and heat sinks are hot to the touch for some
time after the system has been powered down. Allow the memory modules and
heat sinks to cool before handling them.
CAUTION:
Never operate your system with the cooling shroud removed.
Overheating of the system can develop quickly resulting in a shutdown of the
system and the loss of data.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Open the system. See "Opening the System."
3 Remove the expansion card stabilizer. See "Removing the Expansion Card
4 Pull and hold the cooling shroud release latch in the direction of the arrow,
and lift the shroud up and out of the chassis by the touch points. See
Figure 3-9.
book.book Page 92 Tuesday, September 15, 2009 10:08 AM