Cuno 111405-1 - Manual (Page 11)

10
F R E E Z E R C O M P A R T M E N T
A
DJUSTABLE
W
IRE
S
HELVES
TO REMOVE WIRE SHELVES:
• Completely unload the shelf or remove
basket.
• Lift up the rear of the shelf slightly.
• Pull the shelf straight out.
TO LOCK THE SHELF INTO
ANOTHER POSITION:
• Tilt up the front edge of the shelf.
• Lift up the rear of the shelf.
• Insert the hooks into the desired frame
openings.
• Let the shelf settle into place.
Be sure the shelf is level and securely
locked at the rear before reloading it with
food.
F
REEZER
E
LEVATOR
™
S
HELF
This shelf can be
adjusted up or
down without
being unloaded.
To adjust the
height, pull out
the knob on the handle built into the shelf
front. Turn the handle clockwise to raise
the shelf and counterclockwise to lower
the height of the shelf.
TO REMOVE SHELF:
• Completely unload the shelf.
• Slide the shelf out until it stops.
• Push up the tabs under the outside
edges of the shelf behind the bracket
and continue pulling the shelf out, clear
of the frame.
TO REINSTALL SHELF:
• Align the shelf into the guides on the
frame.
• Push the shelf all the way back. (It is not
necessary to push up the tabs for rein-
stallation).
In ordinary use, the Elevator™ shelf frame
assembly does NOT require removal.
In the unlikely event that the assembly
needs removal, it is important to follow the
correct removal procedure. See page 7.
W
IRE
F
REEZER
B
ASKETS
To load or
retrieve items
from a freezer
basket, pull the
drawer for-
ward.
TO REMOVE:
• Pull out the drawer out until it stops.
• Tilt up the front of the basket.
• Lift it completely out.
TO REPLACE:
• Place basket on extended tracks.
• Place tabs on basket sides under tabs on
track. Drawers should sit flat on track.
• Push drawer all the way in.
I
CE
D
RAWER
(Non-dispenser Models)
The automatic icemaker keeps this
drawer stocked with ice. To retrieve ice,
pull open the drawer.
TO REMOVE:
• Pull out the drawer until it stops.
• Reach into the drawer compartment
and move the wire lever arm on the ice-
maker into the up (OFF) position.
• Lift the front of the drawer up.
• Pull the drawer completely out.
TO REINSTALL:
• Align the drawer sides onto the
matching side rails.
• Reach into the drawer compartment
and move the wire lever arm on the ice-
maker into the down (ON) position.
• Push the drawer in.