Cuno 111405-1 - Manual (Page 21)

20
TO REPLACE THE BULB BEHIND
THE LOWER CLIMATEZONE™
DRAWER:
• Turn the power off (“O”) to the
refrigerator at the Main Power switch in
the upper machine compartment (see
page 4).
• Unload and remove both Climate-
Zone™ drawers.
• Remove the air diverter located at the
rear of the fresh food compartment, on
top of the upper ClimateZone™ com-
partment.
• Lift up and remove the glass shelf.
• After the shelf is removed, 2 mounting
screws are visible behind the upper
drawer. Using a
1 ⁄
4
" hex head screw
driver, remove these screws.
• Slide the upper compartment assembly
forward.
• Disconnect the power cords at the plug
by pushing in the tabs and gently pulling
apart. Pull the assembly completely out
and set aside.
• Remove the hex head screws behind
the lower compartment.
• Slide the lower compartment assembly
forward.
• Unscrew the bulb and replace with a
new T8-40 watt bulb.
• Slide the assembly back into its original
position and align the screw holes.
Replace the two screws.
• Lift the upper assembly back into its
original position leaving enough space
to reach the power cords.To reconnect
the upper assembly power cords, align
the properly matching terminals and
snap the power cords back together.
• Push the assembly back into its original
position and align the screw holes.
Replace the two screws and then
replace the glass shelf. Replace the air
diverter strip.
• Replace the drawers.
• Turn the power back on to the refriger-
ator.
L
OWER
F
REEZER
C
OMPARTMENT
• Turn the power off (“O”) to the
refrigerator at the Main Power switch in
the upper machine compartment (see
page 4).
• Remove the freezer basket or ice drawer
that is located in front of the light (select
models).
• Using a phillips screwdriver, remove the
mounting screw on the light shield.
• Unscrew the bulb and replace with a
T8-40 watt appliance bulb.
• Reinstall the light shield.
• Reinsert the freezer
basket or ice drawer.
• Turn the power back
on to the refriger-
ator.
I
CE AND
W
ATER
D
ISPENSER
L
IGHT
TO REPLACE:
• Turn the power off (“O”) to the
refrigerator at the Main Power switch in
the upper machine compartment (see
page 4).
• Locate the light bulb in the dispenser
area to the left of the actuator pad.
• Remove bulb.
• Replace the bulb, using a 120V, 7 watt
bulb.
• Turn the power back on to the refriger-
ator.
IMPORTANT:
• Do not remove the foam piece
between the ClimateZone™ drawers.