Cuno 111405-1 - Manual (Page 20)

19
M A I N T E N A N C E
C
ONDENSER
Cleaning of the condenser is recom-
mended every 3-6 months.
TO CLEAN:
• Remove Machine Compartment cover
(see page 4).
• Turn the power to the unit off using the
Main Power switch.
WARNING: Always re-
member to turn off (“O”) the
power to the refrigerator at the
main power switch and to wear
gloves when replacing light bulbs.
TO REPLACE THE BULB BEHIND
THE UPPER CLIMATEZONE™
DRAWER:
• Turn the power off to the refrigerator
at the Main Power switch in the upper
machine compartment (see page 4).
• Unload and remove the upper
ClimateZone™ drawer.
• Use the soft
brush vacuum
a t t a c h m e n t
to loosen dust
and lint on
the condenser fins. Vacuum to remove
the soil.
• After cleaning, turn the Main Power
switch back on.
• Replace the machine compartment
cover.
L
IGHT
B
ULB
R
EPLACEMENT
U
PPER
F
RESH
F
OOD AND
F
REEZER
C
OMPARTMENTS
There are light bulbs at the top of each
compartment.
NOTE:
Turning the power off on the elec-
tronic control panel inside the refriger-
ator stops cooling only in both com-
partments. It DOES NOT turn off
power to the unit.
TO ACCESS THE UPPER LIGHT
BULB AREA IN EITHER
COMPARTMENT:
• Push in on
the finger-
tabs located
behind the
electronic control panel at the top of
the compartment.
• Lower the light shield.
• Replace the burned out bulb(s) with
standard A15-40 watt appliance bulb(s).
Available from your dealer (part
number 31956).
• After replacing
the bulb(s), push
the light shield
up into its orig-
inal position.
L
OWER
F
RESH
F
OOD
C
OMPARTMENT
There is a T8-40 watt bulb located behind
each ClimateZone™ drawer.
Replace-
ment bulbs are available from your dealer
(MCS part number 61008236).
IMPORTANT:
• To avoid damage to the Climate-
Zone™ drawers, power must be
turned off at the Main Power switch
(see page 3) before changing the bulb.
• Remove the ClimateZone™ Air
Diverter located at the rear of the fresh
food compartment.
• Lift up and remove the glass shelf.
Air Diverter
Strip
Shelf
• After the shelf is
removed, 2 mounting
screws are visible
behind the drawer.
Using a
1 ⁄
4
" hex head
screw driver, remove
these screws.
• Slide the compartment assembly forward.
• Unscrew the bulb and replace with a
new T8-40 watt bulb.
• Slide the assembly back into its original
position. Align the screw holes, making
sure air ducts are in alignment. Replace
the two screws. Replace the shelf and
the air diverter strip. Reinsert the
drawer into the compartment.
• Turn the power to the refrigerator back
on.
IMPORTANT:
• Do not remove the foam piece
between the ClimateZone™ drawers.