Cuno 111405-1 - Manual (Page 6)

5
T
EMPERATURE
A
DJUSTMENTS
• Allow the temperature to stabilize for
24 hours after loading the refrigerator
before making any temperature adjust-
ments.
• The first touch of the up or down
arrow shows the current temperature
setpoint.
• Subsequent touches of the pad
raise the temperature set point or
the pad lowers the temperature
set point.
• The display will show the new setpoint
for approximately three seconds, then
return to the actual temperature
currently within that compartment.
• Limit temperature changes to one
degree at a time. Allow the new tem-
peratures to stabilize for 24 hours
before making a new temperature
adjustment.
D
OOR
A
LARM
The Door Alarm will
alert you when one of
the doors has been left
open for 10 continuous
minutes. When this hap-
pens, the compartment light will go out
and a chime will sound every few seconds
until the door is closed or the Door
Alarm pad is pressed to deactivate the
function.
• Press the Door Alarm pad to activate.
A chime will sound and ON will illumi-
nate.
E L E C T R O N I C C O N T R O L C E N T E R
U
NIT
P
OWER
Touch this pad to start or
stop cooling and turn off the
lights in both the fresh food
and freezer compartments.
This pad DOES NOT shut
off power to the refrigerator.
To turn off all power to the refrigerator,
turn the Main Power switch OFF or “O”
(see page 4).
NOTE:
Allow the refrigerator to run for 8-12
hours before loading. This ensures
appropriate temperatures for food
storage.
IMPORTANT:
Turn off all power to the refrigerator at
the main power switch whenever
changing light bulbs, cleaning or serv-
icing this refrigerator.
I
NITIAL
T
EMPERATURE
S
ETTINGS
Temperatures are preset at 37° F (3° C) in
the fresh food compartment and 0° (-18° C)
in the freezer compartment. The display
will show the average compartment tem-
peratures, based on several measurement
points within the compartment.
The electronic control center is located at
the top of the fresh food compartment.
NOTE:
Thermometers placed in the refriger-
ator may record a temperature slightly
above or below the displayed tempera-
ture. This is normal as the displayed
temperature is an average.
• Press the Door Alarm pad again to
deactivate.
• When the alarm has sounded, close
door to reset.
OR
• Press the Door Alarm pad to deacti-
vate. Press again to reactivate, if
desired.
W
ATER
F
ILTER
• WORKING is
illuminated when
a water filter has
been installed. It
will not illumi-
nate when the
filter bypass is in
place (see page 13 for information on
installation of the water filter or
bypass).
• ORDER will illuminate when 90 per-
cent of the volume of water for which
the filter is rated has passed through
the filter.
OR
Eleven months have elapsed since the
filter has been installed.
• REPLACE illuminates when the rated
volume of water has passed through the
filter or 12 months have elapsed since
the filter was installed. A new filter
should be installed immediately when
REPLACE is illuminated.
When the new filter is installed, the
WORKING light will reilluminate. See
page 13.
NOTE:
Power to the refrigerator must be ON
when the filter is changed for the
water filter monitoring system to reset
and change back to the “WORKING”
indicator.
NOTE:
Temperatures displayed may vary from
set point due to door openings or
during defrost.