Clarion DXZ946MP - Manual (Page 54)

54
DXZ946MP
English
Main Item Sub-item
SOUND CENTER-SP / SRD-SP / SUB-WOOFER
• Setting the speaker ON/OFF (cf. page 54)
FRONT HPF / CENTER HPF / SRD HPF / SUB-W LPF
• Adjusting the speaker filter frequency (cf. Page 54)
SP GAIN
• Adjusting the speaker output level (cf. page 41)
DELAY CENTER-SP / SRD-SP
• Adjusting the speaker delay time (cf. page 55)
DOLBY D D-RANGE
• Adjusting the dynamic range (cf. page 55)
PL II CONT PANORAMA / DIMENSION / CTR WIDTH
• Setting the music mode in detail (cf. page 42)
● Setting items
Adjusting the filter
frequencies of speakers
(FRONT HPF/CENTER HPF/
SRD HPF/SUB-W LPF)
This function allows you to adjust the filter
frequency matched to the speakers you are
using.
• A speaker that was turned off in the section
“Setting speakers on or off (CENTER-SP/
SRD-SP/SUB-WOOFER)” is not displayed.
• The factory default setting for “FRONT HPF”
or “SRD HPF” is “THROUGH” (no filter), and
for “CENTER HPF” or “SUB-W LPF” is
“120Hz”.
■ Filter adjustment
FRONT HPF/CENTER HPF/SRD HPF
(high-pass filter adjustment)
This filter cuts bass sound from the front center
and surround speakers.
THROUGH
➜ 50Hz ➜ 80Hz ➜ 120Hz
Set the filter matched to the speaker when
small-diameter speakers are used.
THROUGH
Set this when using speakers that can
generate bass. THROUGH cannot be set at
CENTER HPF.
SUB-W LPF (sub-woofer low-pass filter
adjustment)
This filter cuts treble sound from the sub-woofer.
50Hz
➜ 80Hz ➜ 120Hz
Set the filter frequency to match the sub-woofer.
1. Press the [A] button to set to the adjust
mode.
5.1ch Surround Decoder Operations
Setting speakers ON/OFF
(CENTER-SP/SRD-SP/SUB-
WOOFER)
Set the center speaker (CENTER-SP), surround
speaker (SRD-SP) and sub-woofer (SUB-
WOOFER) ON/OFF.
Be sure to set this setting to “OFF” when there
is no center speaker, surround speaker or sub-
woofer.
• The factory default setting is “ON”.
1. Press the [A] button to set to the adjust
mode.
2. Touch on the setting item display to
select “CENTER-SP” under “SOUND”,
“SRD-SP” under “SOUND”, and “SUB-
WOOFER” under “SOUND”.
ADJUST MODE
CENTER - SP
SOUND
ON
3. Either touch on the right of the
display, or turn the [ROTARY] knob to select
“ON” or “OFF”.
∗
In the case of “SUB-WOOFER”, select
one of “ON+”, “ON-” or “OFF”.
Normally, select “ON+”. However, when
“ON-” is set, an effect in the low range can
be strongly felt.
4. Press the [A] button to return to the original
mode.