Classe Audio Surround Sound Processor SSP-800 - Manual (Page 42)

42
in use Th is button identifi es active inputs. If the In Use button is highlighted, then
the Input is active. If the In Use button is NOT highlighted, then the input is
considered inactive and is removed from the source selection list.
Deselecting the In Use button for unused inputs is a good way to simplify
source selection. Th
e Source menu on the Home page only lists active inputs so,
if the In Use button is NOT highlighted in the input setup menu, that input
does NOT appear in the Source menu.
video Th e Video button should be used when setting up video sources. It opens the
Input Video Connector menu which lists the available video connections on
the rear panel, allowing you to identify which rear panel connection the input
should use. Any of the rear panel video inputs are assignable to any of the input
setups.
next input Th e Next Input button scrolls through the inputs from Input 1 to Input 20. So,
once you’ve completed the Input 1 setup, click the Next Input button to access
the Input 2 setup controls, and so on through Input 20.
NOTE: Th e Back button returns to the previously viewed menu.
triggers Th e SSP-800 has two available trigger controls. Each may be programmed to
either “logic” (12V) or “inverse logic” (0V) settings. Th e ability to change the
way the trigger operates can solve installation-specifi c problems that otherwise
require external devices that add to both the cost and complexity of your system.
Th e Event button is used to assign the trigger activation to a specifi c event. Th e
triggers can be associated with the Standby mode, a specifi c input, confi guration,
surround processing mode activation, or even a combination of these. To use the
Inverse Logic option, simply highlight the Inverse Logic button on the Triggers
setup page.
For more information on the use of DC triggers, we recommend you speak with
your authorized Classé dealer.