Classe Audio Surround Sound Processor SSP-800 - Manual (Page 53)

53
remote Fkeys Th e remote control supplied with the SSP-800 has four function keys (Fkeys),
each of which gives you instant access to a specifi c system function that might
otherwise be buried in the menu system.
For example, if you use the balance control frequently, you may want to consider
programming one of the Fkeys to directly access the balance control. By saving
the balance control as an Fkey function, you do not need to access the menus
to change the parameter..
Th e remote control F1 to F4 buttons correspond to the Function Keys displayed
on the touchscreen. Select the Function Key that you would like to program,
Th
en to select the one you want simply scroll through the list (by touching
either the up or down arrows on the right), and then touch the specifi c function
you want that Fkey to perform.
important note on Fkey use All Classé remote controls provide these same four Fkeys, so that you need not
worry about which remote you happen to pick up. Th
us F1 on the Surround
Sound Processor’s remote control sends the same infrared signal as F1 on the CD
player’s remote control.
While this is intended to minimize confusion amongst diff erent remotes (since
this aspect of them will all perform identically), you should take care when
assigning diff erent functions on diff erent components to the same Fkey. Doing
so can result in two components doing two diff erent things at once, in response
to a single press of a button on the remote control. Th
is can sometimes be
useful. As an example, F1 could set the Surround Sound Processor to the CD
input, and also set the CD player to Play, both from the press of a single Fkey.