Chicago Pneumatic CS7000 - Manual (Page 24)

6159939130 CS7000 Controller Hardware Overview Manual
Page 2-8 39-30-41365
Gen2 Tool Control Module (TCM)
The TCM, shown in Figure 2-6, is a device that controls a single DC electric tool. The TCM and its
attached tool are referred to as a spindle. The TCM houses both the servo amplifier and DCM.
Figure 2-6. Front View of the TCM
WARNING! !!!! This servo contains a fast discharge circuit to discharge
the internal capacitors within a few seconds. However, you
should still be careful when handling the TCM. A “bus
voltage present” light on the front of the unit will
extinguish when the bus voltage has dropped below
approximately 70VDC.