Dell PowerEdge T300 - Manual (Page 122)

122
Installing System Components
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
2 Remove the system cover (see "Removing the System Cover" on page 66).
3 Open the expansion card cover (see Figure 3-7).
4 Disconnect the chassis intrusion switch cable from the INTRUSION
connector on the system board (see Figure 3-30).
5 Slide the chassis intrusion switch out of the securing bracket notch, then
remove the switch and its attached cable from the system.
Figure 3-30. Removing and Installing the Chassis Intrusion Switch
1 securing bracket notch 2 chassis intrusion switch
3 INTRUSION connector on system
board
2
1
3
book.book Page 122 Sunday, June 21, 2009 10:04 AM