Dell PowerEdge T300 - Manual (Page 38)

38
About Your System
TPM operation is
pending. Press I to
Ignore or M to
Modify to allow
this change and
reset the system.
WARNING: Modifying
could prevent
security.
Configuration change has
been requested. Press I to continue system
boot. Press M to modify the
TPM setting and restart.
Unexpected
interrupt in
protected mode
DIMMs are improperly
seated or the
keyboard/mouse controller
chip has failed. Reseat the DIMMs. See
"Troubleshooting System
Memory" on page 146. If the
problem persists, see
"Getting Help" on page 175.
Unsupported DIMM
detected in the
RAID DIMM slot!
DIMM installed in RAID
DIMM slot is not
supported. See "Troubleshooting System
Memory" on page 146. If the
problem persists, see
"Getting Help" on page 175.
Unsupported RAID
key detected.
The RAID key installed in
the system is not
supported on this system. Information only.
Utility partition
not available
The <F10> key was
pressed during POST, but
no utility partition exists
on the boot hard drive. Create a utility partition on
the boot hard drive. See the
CDs that came with your
system.
Warning: A fatal
error has caused
system reset!
Please check the
system event log!
A fatal system error
occurred and caused the
system to reboot. Check the SEL for
information that was logged
during the error. See the
applicable troubleshooting
section in "Troubleshooting
Your System" on page 133 for
any faulty components
specified in the SEL.
Warning! No micro
code update loaded
for processor n
A microcode update
failed. Update the BIOS firmware.
If the problem persists, see
"Getting Help" on page 175.
Table 1-6. System Messages (continued)
Message Causes Corrective Actions
book.book Page 38 Sunday, June 21, 2009 10:04 AM