Dell PowerEdge R815 - Manual (Page 123)

Installing System Components 123
Internal Dual SD Module (Optional)
Removing the Internal Dual SD Module
When the Redundancy option is set to Mirror Mode in the Integrated
Devices screen of the system setup program, the information is replicated
from one SD card to another. See "Integrated Devices Screen" on page 60.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 76.
3 If installed, remove the SD cards from the internal dual SD module. See
Figure 3-1.
4 Disconnect the cable from the internal dual SD module. See Figure 3-22.
5 Lift the latch securing the internal dual SD module to the front-chassis
assembly and lift the module out of the assembly. See Figure 3-22.
6 Close the system. See "Closing the System" on page 77.
7 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
book.book Page 123 Wednesday, December 18, 2013 2:48 PM