Dell PowerEdge R815 - Manual (Page 133)

Installing System Components 133
SAS Backplane
Removing the SAS Backplane
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 If installed, remove the front bezel. See "Removing the Front Bezel" on
page 75.
2 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
3 Open the system. See "Opening the System" on page 76.
CAUTION: To prevent damage to the drives and backplane, you must remove the
hard drives from the system before removing the backplane.
CAUTION: You must note the number of each hard drive and temporarily label
them before removal so that you can replace them in the same locations.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 88.
5 Remove all hard drives. See "Removing a Hard-Drive Carrier" on page 80.
6 Disconnect the SAS data cable(s) and power cable from the backplane.
See Figure 3-27.
7 Push the blue release tabs in the direction of the arrows and slide the
backplane upwards.
8 Pull the backplane away from the system until the securing slots on the
backplane are free from the tabs on the front-chassis assembly.
book.book Page 133 Wednesday, December 18, 2013 2:48 PM