Compaq 102 - Manual (Page 72)

Remove the display assembly:
1. Release the tape securing the WWAN antennas (1).
2. Disconnect the following cables from the system board:
(2) Display panel cable
(3) Microphone cable
(4) Speaker cable
(5) WLAN cables
(6) WWAN cables (select models only)
CAUTION: Support the display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other computer
components.
3. Remove the 4 Phillips PM2.5×4.0 screws (1) that secure the display assembly to the computer.
NOTE: One screw on the left hinge (2) also secures the display panel cable ground strap.
64 Chapter 4 Removal and replacement procedures