Dell Metered PDU LCD - Manual (Page 59)

59 Serial Interface Operation |
factory_defaults command
Use this command to reset the rPDU configuration to the factory defaults.
Usage
<rPDU>factory_defaults
Reset the rPDU configuration to the factory defaults
rPDU>factory_defaults
Example
rPDU>factory_defaults
Setting configuration to defaults on rPDU.
Saving configuration to flash on rPDU... Done.
help command
Use this command to list all available rPDU CLI commands or receive detailed help on specified commands.
Usage
rPDU>help
rPDU><command
> help
where:
<command> = alarm, current, exit, factory_defaults, network, power, reboot, sensors, temperature,
voltage, ver
List all available rPDU CLI commands
rPDU>help
Example
rPDU>help
Available commands:
alarm
current exit factory_defaults
help network power reboot
sensors temperature voltage ver
List detailed help on a specific rPDU CLI command
rPDU><command
> help
Example
rPDU>alarm help
Usage: alarm
alarm [<threshold>]]
alarm [<threshold> X|Y|Z]] (for three-phase models)
Sets the threshold for the alarm level to <threshold> on rPDU
<threshold> should be between 1A and the maximum current or 100W and maximum
watt rating.