Dell Dimension 4600C - Manual (Page 71)

Adding Parts
71
10 Close the computer cover (see page 72).
11 Attach the computer stand (see page 12).
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
12 Connect your computer and devices to electrical outlets, and turn them on.
13 Right-click the My Computer icon and click Properties.
14 Click the General tab.
15 To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Removing Memory
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
NOTE:
Memory purchased from Dell is covered under your computer warranty.
1 Shut down the computer through the Start menu (see page 21).
2 Ensure that your computer and attached devices are turned off. If your computer and
attached devices did not automatically turn off when you shut down your computer, turn
them off now.
NOTICE:
To disconnect a network cable, first unplug the cable from your computer and then unplug it
from the network wall jack.
3 Disconnect any telephone or telecommunication lines from the computer.
4 Disconnect your computer and all attached devices from their electrical outlets, and then
press the power button to ground the system board.
5 Remove the computer stand (see page 12).
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet
before opening the cover.
6 Open the computer cover (see page 58).
7 Press out the securing clip at each end of the memory module connector.
8 Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from
the connector.