Dell PowerEdge RAID Controller H200 - Manual (Page 68)

68
Troubleshooting
MPT BIOS Fault xxh
encountered at
adapter PCI (xxh,
xxh, xxh)
Fault 01: No I/O port assigned to the adapter.
Fault 02: A MPT firmware fault occurred.
Fault 03: No image for firmware download boot.
Fault 04: Firmware download boot checksum error.
Fault 05: IOC hardware error.
Fault 06: MPT firmware communication error.
Fault 07: PCI bus master error.
Fault 08: String image (messages) not found.
Fault 09: String memory allocation failed.
Fault 0A: String upload failed.
Fault 0B: String image was invalid.
Fault 0C: Unsupported IOC configuration.
Fault 0D: Timeout waiting for IOC to reply.
Fault 0E: Transmit doorbell handshake error.
Fault 0F: Receive doorbell handshake error.
Fault 10: No memory mapped I/O address assigned.
Fault 11: IOC facts failure.
Fault 12: IOC initialization failure.
Fault 13: Port enable failure.
MPT BIOS Fault xxh
encountered at
adapter PCI (xxh,
xxh, xxh)
When xxh is 02 or 11, a 4-digit hexadecimal fault
value may be displayed with this message. Ensure
that you make a note of this value and contact
technical support for assistance.
Table 7-4. BIOS Error Messages (continued)
Message Meaning
PERC H200.book Page 68 Tuesday, July 13, 2010 4:15 PM