Dell PowerEdge RAID Controller H200 - Manual (Page 69)

Troubleshooting
69
ERROR: Preferred boot
device is missing,
reconfiguration is
suggested!
The message indicates that the preferred boot
device selected in the Configuration Utility is
no longer available. You must enter the
Configuration Utility and specify the physical
or virtual disk to be the boot device. For details
on assigning boot device preference, see
"Assigning a Preferred Boot Device" on page 59.
One or more
unsupported device
detected!
There is a topology error during device scan.
SAS Address NOT
programmed on
controller in
slot xx
The SAS address (World Wide ID) equals zero
and is not programmed
WARNING! Foreign
Metadata detected
Detected metadata is not supported by
integrated RAID.
Device has an
unsupported sector
size, not 512
The sector size is not 512 bytes that is a
requirement for boot support.
Bus master ERROR! The bus master enable was not set for the chip.
Error: Preferred boot
device is missing,
reconfiguration is
suggested!
The selected boot device is not found.
Table 7-4. BIOS Error Messages (continued)
Message Meaning
PERC H200.book Page 69 Tuesday, July 13, 2010 4:15 PM