Dell PowerEdge T410 - Manual (Page 158)

156
Troubleshooting Your System
Troubleshooting the Video Subsystem
1 Check the system and power connections to the monitor.
2 Check the video interface cabling from the system to the monitor.
3 Run the appropriate diagnostic test. See "Running the System
Diagnostics" on page 173.
If the tests run successfully, the problem is not related to video hardware.
If the tests fail, see "Getting Help" on page 185
Troubleshooting a USB Device
1 Use the following steps to troubleshoot a USB keyboard and/or mouse.
For other USB devices, go to step 2.
a Disconnect the keyboard and mouse cables from the system briefly
and reconnect them.
b Connect the keyboard/mouse to the USB port(s) on the opposite side
of the system.
If the problem is resolved, restart the system, enter the System Setup
program, and check if the nonfunctioning USB ports are enabled.
c Replace the keyboard/mouse with another working keyboard/mouse.
If the problem is resolved, replace the faulty keyboard/mouse.
If the problem is not resolved, proceed to the next step to begin
troubleshooting the other USB devices attached to the system.
2 Power down all attached USB devices and disconnect them from the system.
3 Restart the system and, if your keyboard is functioning, enter the system
setup program. Verify that all USB ports are enabled. See "Integrated
Devices Screen" on page 69.
If your keyboard is not functioning, you can also use remote access. If the
system is not accessible, see "SAS Backplane Board Connectors" on
page 181 for instructions on setting the NVRAM_CLR jumper inside your
system and restoring the BIOS to the default settings.
book.book Page 156 Tuesday, June 9, 2009 4:09 PM