Installing the cooling shroud – Dell PowerEdge T410 User Manual
Page 93
Installing System Components
93
Figure 3-6.
Removing and Installing the Cooling Shroud
Installing the Cooling Shroud
1 Align the cooling shroud with the alignment guides in the system.
2 Hold the touch points on the cooling shroud and carefully lower the
cooling shroud into the system. Ensure that no cables are pinned under
the edges of the cooling shroud.
3 Hold the touch points and lower the expansion card stabilizer.
4 Close the system. See "Closing the System" on page 91.
5 Place the system upright and on its feet on a flat, stable surface.
6 Rotate the system feet outward.
7 Reattach any peripherals, then connect the system to the electrical outlet.
8 Turn on the system and attached peripherals.
1
expansion card stabilizer touch
points (2)
2
expansion card stabilizer
3
cooling shroud
4
cooling shroud touch points (2)
1
2
3
4
book.book Page 93 Tuesday, June 9, 2009 4:09 PM